Rear axle spring perch welding

Spring perches tacked in place when mocked up in the frame with engine and trans in. Output shaft sat at 3.5 degress and I decided to set the rear axle pinion at 3.0 degrees. The perches ended up at 5.2 degrees of  of the mounting surface of the centre section. 

Back from work. I had a guy at work helping me out with the welding as my own mig welder was way to little for this.

5 degrees between centre section mounting surface and spring perches, results in 3 degrees up from horisontal plane on the pinion, and the engine leans back 3.5 degrees.